IPCOMM-POE

AIDA Imaging Portable Wireless Video & Control Transmitter with PoE+ Injection - Black

° Connect to any Wi-Fi router with EASE!
Its as easy as locally connecting your IPCOMM-POE to your computer, connecting to the Wi-Fi router, and following the steps to get wireless transmission started!

° Bringing Power to a Camera near you!
With the ability to use the DC12V or NPF type battery (sold separately,) you can supply beloved PoE+ power to your camera, simultaneously powering and sending video and control over the network!

° Multiband-lingual kind of device..
With the power to connect to a 2.4GHz or 5GHz Wi-Fi router, the IPCOMM-POE has you covered on almost any router out on the field or market!

° Unlimited Potential
With a mobile setup, you bring any IP camera power, video transmission, and control over a wireless network.
With nothing holding the camera down, this brings unlimited potential to any streaming solution you can think of at a GREAT price!

° Housing BUILT to last
With AIDA's special hardened aluminum housing formula, you can expect your IPCOMM-POE to perform when, and where you need it most!

° Kbps based, not resolution!
With the ability to send up to 50Mbps MAX, you can send fluid 720 to 4K video with ease over your network! Some things to note to achieve this <10ms ideal scenario:
Limit the amount of obstacles between the router and IPCOMM-POE
Ensure the signal strength seen when setting the IPCOMM-POE up is above 60%
Ensure the bandwidth sent by the camera to the router is within 2Mbps~50Mbps, this mostly depends on your signal strength.
Anything higher will cause delay and video rupturing.
Using the SRT protocol (Found on all AIDA IP cameras) can drastically help video tearing for further distance / lower bitrate video, however it comes at the price of a little more latency.

° It just keeps RUNNIN RUNNIN!
The device powered by 12VDC will continue to run until power gives up, making it a great permanent solution for some tough to reach spots.
With a 7000maH NPF battery however, you can expect up to 3hr run time on PTZs, and 6hr run time on POV cameras! When the battery runs out, just swap it with a newly charged NPF battery, and let the show continue!

° Mission Control - Status, over!
Keep on top of your stream with a battery level indicator, as well as PoE+ and PWR indicators to let you know mission control know if there is a problem!