Godox LiteFlow Lightstream reflector Kit K1
GodoxEAN:6952344233207
₦ 1,948,785.91
VAT Included
VAT Included
Available in 15 days
Godox LiteFlow Lightstream reflector Kit K1
The Godox LiteFlow Lightstream reflector Kit K1 is the complete set of mirrored reflector panels from the Knowled LiteFlow range: all four versions in four sizes, with the mounting hardware and cleaning kit.
With these panels you bounce the light from a fixture exactly where you want it. On set that saves fixtures, stands and power.
- Sixteen panels: D1 to D4 in 7, 15, 25 and 50 cm
- From hard light to soft strip light, each with its own label colour
- Only 3 percent light loss on the bounce
- WMR rail holder and WMS mounting stud for hanging the panels
- SW01 safety wire, gloves, cleaning spray and wipes
The four versions
D1 with the blue label gives hard light and extends the light path so it falls off naturally.
D2 with yellow spreads direct light and redirects it.
D3 with green gives soft, natural shadows and is the one for fill.
D4 with red pulls the beam into a strip.
The four sizes
The 7 cm panel weighs 46 grams and sits close to a detail.
The 15 and 25 cm sizes weigh 167 and 403 grams.
The 50 cm panel weighs 1.43 kilos and lifts a whole corner of the set.
All sizes work on the same principle.
Mounting
The WMR rail holder and the WMS stud hang the panels on a rail or put them on a stand.
The SW01 safety wire holds a panel if the mount comes loose.
The gloves, the spray and the ten wipes keep the mirrored face free of fingerprints.
The Godox LiteFlow Lightstream reflector Kit K1 is the complete set of mirrored reflector panels from the Knowled LiteFlow range: all four versions in four sizes, with the mounting hardware and cleaning kit.
With these panels you bounce the light from a fixture exactly where you want it. On set that saves fixtures, stands and power.
- Sixteen panels: D1 to D4 in 7, 15, 25 and 50 cm
- From hard light to soft strip light, each with its own label colour
- Only 3 percent light loss on the bounce
- WMR rail holder and WMS mounting stud for hanging the panels
- SW01 safety wire, gloves, cleaning spray and wipes
The four versions
D1 with the blue label gives hard light and extends the light path so it falls off naturally.
D2 with yellow spreads direct light and redirects it.
D3 with green gives soft, natural shadows and is the one for fill.
D4 with red pulls the beam into a strip.
The four sizes
The 7 cm panel weighs 46 grams and sits close to a detail.
The 15 and 25 cm sizes weigh 167 and 403 grams.
The 50 cm panel weighs 1.43 kilos and lifts a whole corner of the set.
All sizes work on the same principle.
Mounting
The WMR rail holder and the WMS stud hang the panels on a rail or put them on a stand.
The SW01 safety wire holds a panel if the mount comes loose.
The gloves, the spray and the ten wipes keep the mirrored face free of fingerprints.