MinFerno

AUDIO INPUT

Input Type: Neutrik 3 pin XLR

Input Impedance: Mic: 2k4
Line 100k

Equivalent Input Noise: 127dBu (22Hz-22KHz) RMS A weighted Terminated with 300 Ohms

Frequency response: Mic -2dBu @25Hz flat @50Hz till 22kHz (+/- 0.25dBu).
Line flat till 22kHz

Distortion at +8dBu: 100Hz = 0.023%
1kHz =0.012%
10kHz = 0.014%

Line Up Gains: Dynamic Mic: 58dB
Mic + Phantom Power: 35dB
Line: 0dB

Gain Range: Mic: -30 to +15dB
Line: +/-15dB

Max Input Before Clipping (@line up):
Dynamic Mic: +10dBU,
Mic+phantom: +18dBu
Line: +18dBu

HEADPHONES

Headphone Impedance: 16-1000 ohm (auto output level to match impedance)
Headphone Noise: -76.6dB @ line up (residual noise)
Headphone Frequency Response: >-0.1dB 22Hz to 22kHz
Headphone THD + Noise (Ref +8dB): 0.008% @ 1kHz
Connection: 6.35mm & 3.5mm stereo jack plugs
Headphone Volume Pot Range: +10dB to Off (can be configured +10dB to -30dB)
Maximum Headphone Output: +16.8dB into 600 Ohms

DANTE/AES67 NETWORK INTERFACE

Physical: 2 x Neutrik Ethercons Cat6 RJ45s & 2 x SFP slots
Type: Fully redundant Primary & Secondary circuits
Sample Frequency: 48K
Resolution: 24 Bit
Control & Routing: Via Free Dante Controller
AES67: Compliant (Can be configured for AES67 via Dante® controller)
NETWORK TYPE: Gigabit Ethernet

POWER

PoE: Can be powered by PoE on either Copper network interface
PoE: Complies to IEEE 802.3af-2003 classification class 0
DC Input: 2.5mm Barrel, Centre +Ve, 9 - 15 Volts
Consumption: Front Panel Power On LED: Bright Blue
Rear Panel Power On Indicators: 1 green LED showing presence of each of the above power sources

PHYSICAL

Size: 144 x 17