MKH 50 P48 UEAN  4006087031094

This michrophone is a high quality, professional condenser microphone specifically designed for spot capturing in recording and sound reinforcement applications. The MKH 50 offers exceptional attenuation at the lateral sections of the capsule, for a focused pick up without off-axis noise. Its wide frequency response and high sensitivity result in pristine audio fidelity, no matter the source. It also has a low-frequency roll-off switch to minimize rumble/noise, and a pre-attenuation switch in case you'll mount the microphone near to high transients. The MKH 50 use +48V Phantom Power, and is more than suitable for capturing vocals or instruments in recording or sound reinforcement.

A pressure gradient condenser mic specifically created for spot recording

Supercardioid polar pattern to provide focused capture and extreme off-axis rejection

Low frequency roll-off switch to minimize rumble and noise

Switchable pre-attenuation provides an additional 10dB of headroom to prevent distortion from close-proximity transient signals

Uses +48V Phantom Power

Transducer Condenser
Polar Pattern super-cardioid
Frequency Response 40Hz to 20kHz
Dynamic Range (Typical) Not Specified by Manufacturer
Signal-to-Noise Ratio 12 (18) dB
Maximum Input Sound Level SPL 134 (142) dB at 1 kHz
Power Requirements 48 V Phantom Power +/- 4V
Output Impedance Nominal: 150 ohms
Min. terminating: 1000 ohms
Output Connectors 3-pin XLR male
Pad -10dB
Low Frequency Roll-Off Yes
Dimensions 6.02 x .98" (153 x 25mm) Length x Diameter
Weight 3.52 oz (100g)